Instructions / Assembly

11
Fireplace Installation
following the dimensions
shown in Figure 5. Note
that a 4" (102 mm) minimum
depth including the thickness
of dry wall is required.
Make sure there is enough
clearance for the cable
coming out from the bottom of
the replace.
!
NOTE: Where there are
close tolerances involved in
wall building or applications
which require a great degree of
precision, we recommend that the
product itself be used to make
the actual measurements for the
wall opening. Dimplex North
America will not be responsible
for inaccuracies in the design or
manufacture of enclosures.
WARNING: Ensure method of
installation does not obscure the
air intake slots on top of unit in
any manner.
Keep a minimum of a 4"
(102 mm) clearance from
top of unit to any surface or
material.
Wire a dedicated, properly 3.
fused circuit with 120 Volt,
15 Amp rating. Allow up to
8' (2.44 m) of service cable
for connecting power supply
to junction box on replace
when installing after nishing
wall.
CAUTION: Use a two (2)
conductor, non-metallic sheath
cable with ground wire (three
(3) wires total) for the incoming
power supply on replace inserts.
Use the appropriate wire to meet
local and national electrical codes
for rated power consumption.
Remove the outer jacket and 4.
strip the individual conductor
from the end.
Loosen the screw securing 5.
the junction box cover and
remove the cover.
Take the cables out from the 6.
junction box, loosen the two
(2) wire nuts and remove the
cord set (Figure 6).
Route the power supply wire 7.
through the knockout on
supplied alternative junction
Figure 5
32"
(813
mm)
14¼"
(362 mm)