Instructions / Assembly

9
Fireplace Installation
for heat exhaust from the bottom
of the replace (Figure 3).
With a wall stud nder, locate 3.
the center of the wall stud,
drive a wood screw into the
stud and leave approximately
⅛" (3 mm) exposed threads
for the replace to hang on.
The second mounting point 4.
should be picked such that it
is farthest (to the left or right)
relative to the rst one among
the seven (7) keyholes (A to
G shown in Figure 2) on the
replace for wall mounting,
these keyholes are 2" (51
mm) apart. For example, if
you plan to use hole B as
the rst mounting hole, the
second mounting hole must
Figure 3
Heat Exhaust
be G.
Other available combinations
are A-G, C-G, A-F, A-E, A-D
and D-G.
Mark the second mounting 5.
screw location; ensure that it
is level with the rst with the
help of the provided bubble
level and the replace itself.
Screw the threaded drywall
anchor in the drywall with a
Philip’s head screwdriver until
the head is at against the
wall surface.
Caution should be taken
when using a power tool to
install a threaded drywall
anchor as the drywall may
distort, tear or slightly buckle
as a result of over-torque.
With a Philip’s head screw 6.
driver, screw the drywall
anchor screw into the drywall
anchor already in the wall,
leave ⅛" (3 mm) exposed
threads for mounting the
replace.
With the glass assembly 7.
taken off, mount the rebox
onto the two (2) mounting
screws.
Mark position of hole “H”.8.
Remove replace from wall.9.