Westcott 12kW Stove Please hand these instructions to the stove user when installation is complete. Leave the system ready for operation and instruct the user in the correct use of the appliance and operation of controls. Installation should only be carried out by a suitably qualified installer that is registered with HETAS (UK) or with the Irish Nationwide Fireplace Organisation (INFO). Installation must comply with Building Regulations.
1 H C L (Dia) J D G A B K F E Table 1 - Dimensions A B C D E F G H J K L Westcott 12kW 688 640 652 326 670 104 50 356 113 538 150 Note: All Dimensions in mm. Dimensions stated may be subject to a slight ± variation. ( 25.4mm = 1”) Table 2 - Technical Specification Nominal heat output Efficiency CO Emission (@13% O2) Westcott 12kW Wood kW 12.1 Solid Fuel (Ancit) kW 12.2 Wood % 73.1 Solid Fuel (Ancit) % 71.0 Wood % 0.68 Solid Fuel (Ancit) % 0.
4 5 2 1 x2 6 Z Z = At least 150mm or to a suitably heat resistant wall (See table 3) Solid, non-combustible material e.g.
10 11 B SEAL CLOSURE PLATE C D A A 12 13
Westcott 12kW -1- IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE Important Safety Advice Please read these instructions carefully before installing or using this appliance. Failure to do so may result in damage to persons and property.
-2- If there is no existing chimney then either a prefabricated block chimney or a twin walled insulated stainless steel flue to BS4543 can be used. These chimneys must be fitted in accordance with the manufacturers instructions and in compliance with Building Regulations. This product must not be installed on a shared flue.
-3- Commissioning Upon completion of installation, the stove and flue system should be tested by a suitably qualified person to make sure it is safe for normal use. A smoke draw test should be completed to check for soundness of joints and seals and also that all smoke and fumes are taken from the appliance up the chimney and emitted safely. First warm the flue with a blowlamp or similar for about 10 minutes. Place a lit smoke pellet on the centre of the grate with the air controls open.
-4- De-Ashing To de-ash the grate insert the notch on the riddle hand tool into the peg on the side of the stove (D - Fig 11), then draw the tool forwards and backwards with a slow positive action (Fig 12). The ash pan should be emptied each time after operating the stove so not to let build up of ash occur. Where possible, it is best to wait until the stove and ash has cooled before removing the ash pan.
-5- After Sales Service As a sign of our commitment to quality, all new Dimplex solid fuel stoves are guaranteed against casting faults and other manufacturing defects for 10 years in the case of non-boiler stoves and 5 years in the case of boiler models, subject to certain conditions and exclusions. The guarantee covers the main body of the stove and external cast parts under normal domestic use - it does not cover use in commercial premises. The guarantee period begins on the date of purchase.
WESTCOTT 12kW 15 4 7 5 2 14 11 10 9 13 3 8 1 16 2 12 WESTCOTT 12kW STOVE - SPARE PARTS Item Description Part No 1 Door Accessory Pack (x1 LH, x1 RH) MF09001 2 Grate Accessory Pack (incl Grate Outer, x10 Grate bars) MF09002 3 Adjustable Grate Plate MF09003 4 Baffle Plate Accessory Pack MF09004 5 Air Wash Deflector Plate 3011015 6 Primary Air Slide MF09006 7 Grate/Ashpan Operating Tool MF09007 8 Front Bar (Log bar) MF09008 9 Legs Accessory Pack (x2 off) MF09009 10 Do
DIMPLEX MILLBROOK HOUSE GRANGE DRIVE HEDGE END SOUTHAMPTON SO30 2DF TEL: 0845 600 5111 FAX: 01489 773050 WEBSITE: www.dimplex.co.uk Republic of Ireland Tel: 01 842 8222 [c]A Division of GDC Group Ltd. All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of GDC Group Ltd.