Service manual

【7-12】
E
LECTRICAL SYSTE
M
Ignition Coil Installation
● Connect the primary winding leads to the ignition coil
terminals
Ignition Coil Inspection
● Remove the ignition coil.
● Measure the primary winding resistance as follows:
○ Connect the tester between the coil terminals.
○ Set the tester to the × 1Ω range, and read the tester.
● Measure the secondary winding resistance as follows:
○ Remove the plug cap by turning it counterclockwise.
○ Connect the tester between the spark plug lead and
terminal.
○ Set the tester to the × 1 kΩ range, and read the tester.
If the hand tester does not read as specified, replace the ★
coil.
○ To install the plug cap, turn it clockwise.