Service manual

【3-11】

BRAK

Caliper Removal

●Removal the Rear wheel (see Wheels/Tires chapter).

●Loose the banjo bolt [A] at the brake hose lower end, and

tighten it loosely.

●Unscrew the caliper mounting bolts [B], and detach the

caliper from the disc.

●Unscrew the banjo bolt and remove the brake hose from the

caliper.

CAUTION

Immediately wash away any brake fluid that spills.

NOTE

○If the caliper is to be disassembled after removal and if

compressed air is not available, disassemble the caliper

before the brake hose is removed.

Caliper Installation

●Install the caliper and brake hose lower end.

○Replace the washers that are on each side of hose fitting

with new ones.

●Tighten:

Torque –

Caliper Mounting Bolts:25N-m(2.5kg-m,18.0ft-lb)

Brake Hose Banjo Bolt:25N-m(2.5kg-m,18.0ft-lb)

●Check the fluid level in the brake reservoir.

●Bleed the brake line (see Brake Line Air Bleeding).

●Check the brake for good braking power, no brake drag,

and no fluid leakage.

WARNING△

Do not attempt to drive the vehicle until a full brake level

is obtained by pumping the brake level until the pads are

ainst each disc. The brakes will not function on the first

application of the level if this is not done.