Service manual

【3-12】
B
RAKE
Rear Brake Pads Removal
●Remove the caliper (see Caliper Removal)
●Remove the Cir-clip [A] and bolt [B]
●Remove:
Anti-rattle Spring [C]
Brake Pads [D]
Brake Pad Installation
●Check the lining thickness (see Brake Pad Wear
Inspection).
●Push the caliper piston in by hand as far as it will go.
●Be sure that the anti-rattle spring is in place.
●Install the pads.
○Be careful not mix it up inboard pads with the out board
pad.
●Tighten:
Torque - Pad Mounting Bolts:18N-m(1.8kg.m,13.0ft.lb)
WARNING△
Do not attempt to drive the vehicle until a full brake level
is obtained by pumping the brake level until the pads are
a
g
ainst each disc. The brakes will not function on the first
application of the level if this is not done.