Service manual

【4-4】
S
USPENSION/STEERIN
G
Suspension Arm Assembly
●When installing the rubber bushing into the arm, lubricate
the outer surface of the bushings with a soap and water
solution.
CAUTION
Do not lubricate the rubber bushings with engine oil or
petroleum distillates because they will deteriorate the
rubbers.
●Position the bushings in the suspension arm as shown using
a suitable bearing driver in the bearing driver set.
Swingarm Removal
●Support the vehicle on a stand or the jack so that the rear
wheels are off the ground.
●Remove:
Rear Wheels
Rear Brake Disc (see Caliper Removal)
Rear shock Absorber Mounting Bolt and nut
Chain
Speedometer Cable
Rear Axle
Swingarm Shaft Nut [A] and Shaft [B]
Swingarm [C]
Swingarm Installation
●Position the swingarm as shown.
●The distance between the frame and left end of the
swingarm is 0.5 mm; also right side distance is 0.5 mm.
●Tighten:
Torque -
Swingarm Shaft Nuts: 110 N-m (11.0 kgf-m, 80 ft-lb)
Swingarm Bush Removal
●Remove:
Seal Cover [A]*2
Chain Guide [B]
Bush [C]*2
Space Tube [D]