Service manual

【6-11】
E
NGIN
E
CYLINDER HEAD
REMOVE
● Remove the camshaft. (Refer to the “Camshaft Remove”
section )
● Remove the carburetor and exhaust muffler..
● Remove the two bolts and then remove the carburetor intake
manifold as show.
● Remove the clip to disconnect the thermostat (Remember to
drain the water in the hoses first)
● Remove the bolt to disconnect the thermostat.
● Remove the two cylinder head bolts.
● Remove the cylinder head.
CYLINDER HEAD DISASSEMBLY
● Remove the valve keepers, retainers, springs, spring seats,
spring seals, valve guides, o-rings and valves by using a
valve spring compressor.
NOTE:
Be sure to compress the valve springs with a valve spring
compressor. Mark all disassembled parts to ensure correct
reassembly.