Service manual

6-21
E
NGIN
E
LEFT CRANKCASE COVER
REMOVAL
Loosen the drive belt air inlet and outlet hose band screws
and disconnect them from the left crankcase cover.
Remove the left crankcase cover bolts and left crankcase
cover.
Remove the gasket and dowel pins.
INSPECTION
Inspect the bearing for allow play in the left crankcase cover
or the bearing turns roughly – Replace.
INSTALLATION
Install the dowel pins and new gasket.
Reverse the “LEFT CRANKCASE COVER REMOVAL”
procedures.
Install the left crankcase cover and tighten the bolts.
Connect the drive belt air inlet and outlet hose and tighten
band screws.
Install the starting cover and outlet hose cover.