Service manual

【6-24】
E
NGINE
CLUTCH/DRIVEN PULLEY
REMOVAL
● Remove the left crankcase cover. (Refer to “LEFT
CRANKCASE COVER REMOVAL”)
● Remove the drive pulley. (Refer to “DRIVE PULLEY
REMOVAL” )
● Remove the o-ring, nut, washer and clutch outer.
● Remove the clutch/driven pulley and drive belt.
SUGGESTION:
If the clutch/driven pulley is damaged, please replace the whole
clutch/driven Assy. to make sure the engine functioning well.
DRIVE BELT INSPECTION
● Check the drive belt for cracks, separation or abnormal or
excessive wear.
● Measure the drive belt width.
Service Limit: 22mm replace if below
NOTE:
Use specified genuine parts for replacement.
CLUTCH OUTER INSPECTION
● Inspect the clutch outer for wear or damage.
● Measure the clutch outer I.D.
Service Limit: ψ153.5mm replace if over
INSTALLATION
Reverse the “Removal” procedure to install the
clutch/driven pulley and driven belt onto the drive shaft.