Service manual

【6-36】
E
NGINE
● Measure the crankshaft run out (A).
Service Limit: 0.10mm replace if over
● Measure the connecting rod big end side clearance (B).
Service Limit: 0.6mm replace if over
● Measure the connecting rod big end radial clearance (C).
Out of specification (0.05 mm) – Replace the crankshaft.
● Turn the crankshaft bearings and check for excessive play.
● Measure the crankshaft bearing play.
Pitting/wear/damage – Replace
CRANKCASE/BALANCER INSTALLATION
● Install the balance shaft and crankshaft into the left
crankcase.
NOTE:
Align the mark on the balance shaft with the mark on the
crankshaft
● Install the dowel pins and new gasket.
● Install the right crankcase and tighten the crankcase attach
bolts.
● Install the timing chain.