Owner`s manual

1
3
V. cleans
⑴First according to the "pressure relief steps" to eject the pressure and coating inside
equipment.
⑵Nozzles and nozzle jacket will be unloaded.
⑶Add suction pipe will be put into clear water bucket or the appropriation dilution.
⑷Put the reflux tube into Paint waste barrels.
⑸Return valve will be installed in the vertical direction
⑹Pressure control buttons will be set in the washing position
(the red area)
⑺Turn on the power switch.
⑻In the solvent recycling equipment, paint residues discharged until clean water or
solvent from the outflow of reflux tube.
⑼Shut the power switch.
⑽Return valve will be set in the horizontal position and open spray gun insurance.
⑾turn on the power switch
⑿ Buttonning up the trigger makes solvents or clear water flush to remain coating inside high
pressure tube and spray gun, until solvents or clear water are jet from the muzzl
⒀shut spray gun insurance.（as the right chart）
⒁Loaded nozzle jacket and open spray gun insurance.
⒂Nozzle will be reversed 180 degrees, sustained gun deduction 1 ~ 2 seconds (cleaning
nozzles), nozzles and nozzle jacket unloaded and cleaned with brushes.(cleaning
nozzle attention to put into a white-washers and nozzles Block, please donot lost.)
⒃Unloading equipment and spray guns on the filter net then clean
⒄Unload suction tube filter and clean .
⒅With piles of rags solvent or clean water equipment, high-pressure hoses and spray
gun all the components of the appearance wipe clean until a surface Adhesion without
coating.
⒆Equipment in the infusion fluid valve 5-6 PSL drop of a closed yellow liquid.
⒇Equipment will be stored in dry, clean and well-ventilated places