Owner`s manual

16
● Suction ring component replacement
⑴In accordance with the "ball valve maintenance steps"
to unload the upper and lower ball valve.
⑵Suction component will be below the two-position
rotary nut removed.
⑶Suction tube components will be slightly shelland pulled
down so that the shell about 1.5 cm from the equipment.
⑷From the field in the suction components will be
introducedslowly shell straight Plunger rod to the
crankshaft andconnecting rod of the bottom of the
T-mount separation.
⑸Will be down from the suction plunger rod components from the shell launched.
⑹Suction components shell will be fixed on the nuts and locator removed.⑺Will be removed
within the shell on the three ring .
⑻Cleaning suction components shell will be installed with new white ring back Shell.
(Installation of the order and direction of making reference to the following diagram).
Note: new suction equipment manufactured components for the black ring ,and
suction component repair packet ring is white .
上部密封圈安装方向 下部密封圈安装方向
O型密封圈在安装时应将上部 O型密封圈在安装时应将下部
密封圈上的凸起面朝下 密封圈上的凸起面朝上
⑼Carefully check plunger rod, if wear or scratches, need immediate replacement.
⑽Will be loaded back on the ball valve and plunger rod screwed tightly .
Note: this link can be used on the crankshaft T-type card which be screwed tightly onto
the piston rod fixation.
⑾Will be embedded in the upper locator nut fixed, and fixed equipment to suction nut shell
components, the manpower to hand rotation.