Owner`s manual

⑿In determining seals ring and locator installed in the correct position, the piston rod will be

components from the suction casing from the bottom to bottom-up equipment, and rubber

hammer to knock plunger rod gently into the suction components, until the plunger rod into the

correct position.

Note: plunger rod and all components required in the load applied to a small lubricants.

⒀fixed nut screwed tightly with the wrench

⒁Will be installed suction components embedded in the top of the bottom of the crankshaft

connecting rod T-type Card notch .

⒂Will be installed suction components pushed up until the suction equipment and

components shell casing not seamless.

⒃the bottom shell of suction Components will be fitted with screws and screwed tightly.

⒄Will be installed under the block components together with the ball valve and cylinder

components installed to suction screwed tightly onto the shell.

⒅Suction pipe will be installed under the block and back with a fixed clasp.

⒆Will be return tube back to the installation of suction screwed tightly onto the components.

⒇According to the "operation steps" to activate the equipment and inspection equipment

availability drip.

（

）

According to the "operation steps" to activate the equipment and inspection equipment

availability drip.

Note: Even if there is a seal ring damage, but also the need to replace the entire

maintenance package Accessories Group.

7.Frequently asked questions and troubleshooting

equipment Frequently Asked Questions

1. Power circuit or not to poor contact 1. Check circuit

2. Set too low pressure 2. Set too low pressure

3 electrical Brush damaged or bad contact. 3.electrialBrushreplacement or

inspection.

4. Motor burn

4. Replacement motor

5. Switch damage 5. Replacement switch

Motor does not

operate

6.Equipment overload, power switch up 6. pressed to the power switch

！！ warning！！

Refrain in the installation, use ball valve plunger rod or tube

clamp-vices, this will cause the piston-cylinder damage caused

by the leaking of phenomenon.