Instructions

www.getdio.com
EN | 3
Contents
This kit contains:
A tubular motor 45mm in diameter (35mm for Ref.: MVR-40-10RF)
with a 60mm diameter drive wheel (40mm for Ref.: MVR-40-10RF)
A 60mm diameter octagonal ring (40mm for Ref.: MVR-40-10RF)
A retaining bracket
Retaining screws
Retaining pin
An end stop adjustment tool
A one channel DIO 1.0 remote control unit
• Do not disassemble the product. Do not insert sharp objects into the motor.
• Fit the power cable inside waterproof protective tubing if it is to be installed externally in
order to avoid any possible ingress of water into the motor.
• Do not use the motor if the power cable is damaged, and contact customer service or the
dealer immediately.
• Do not make holes in the motor and pay particular attention to the length of the retaining
screws of the roller of the shutter or blind.
• Please refer also to the shutter or blind instruction manual for additional safety instructions.
Note for the warranty:
Important! No warranty is accepted for the product in the event of faults or problems due to non-
compliance with the standards for installation.
A.
B.
C.
D.
E.
F.
G.