Instructions

www.getdio.com
EN | 4
Installation
I. Installing the motor
Please follow the instructions for your shutter or blind to remove it and gain access to the roller.
Warning, before installing the motorised unit, make sure you block o the existing wired switch
if you had an electrical installation or remove any equipment which is not needed for a motorised
operation such as the strap or the hand crank.
Warning, before installing, check that the motor is suitable for the shutter to be automated (see
product box).
1 Measure the exact distance between the following two points (see diagram):
2 Insert the motor into the shutter roller, taking care to align the octagonal ring mark with the
adjustment line located on the head of the motor. Only the head of the motor may extend
beyond the roller.
+