Manual

1.877.817.6028
www.DiodeLED.com
[e-mail] www.DiodeLED.com
INSTALLATION GUIDE
1 OF 4
0-10V DIMMABLE LED DRIVER
®
• Install in accordance with the Naonal Electric Code, and local
regulaons.
• This product is intended to be installed and serviced by a qualied,
licensed electrician.
• Only install compable LED xtures and controls. Contact technical
support or visit the product page for compable products.
• Proper heat dissipaon will prolong the working lifespan of this product.
Install in a well-venlated area free from explosive gases and vapors.
• Ensure applicable wire is installed between driver, xture, and any
controls in between. When choosing wire, factor in voltage drop,
amperage rang, and type (in-wall rated, wet locaon rated, etc.).
Inadequate wire installaon could overheat wires, and cause a re.
• Do not install if product has any visible damage.
• Do not modify or disassemble this product beyond instrucons or the
warranty will be void.
Safety & Warnings
Dry/Wet
Location
Dimmable
Read all warnings and installaon instrucons thoroughly.
WARNING
IG072914-1.2
Prior to installaon, ensure all components are a compable system. Congure and pre-test your LED system prior to permanent installaon to ensure
all components are operang correctly. Install in accordance with the NEC and local regulaons.
1. Turn OFF 120~277VAC power at the main breaker prior to installaon.
2. Determine locaons to install the driver, xture and control. See ‘System Diagram.’
3. Aach appropriate load and 0-10V control/dimmer to the driver. See ‘Wiring Connecons.’
4. Install addional components and accessories. Once complete, turn main power ON.
Input Voltage 100-277VAC~ at 50/60Hz
Output Voltage See driver label for output voltage.
Ambient Temp † -40 ~ +122°F (-40 ~ +50°C)
Max Load
Ensure to de-rate the labeled load 20%.
See dimmer switch for min. load requirements.
† Do not install product in an environment outside the listed ambient
temperature. Ensure adequate airow and heatsinking is considered
when mounng/installing.
For full specicaons, see the ‘Specicaon Sheet’ at the online product
page.
Ensure applicable wire is installed between driver, xture, and any controls between. When choosing wire, factor in voltage drop, amp rang, and type
to prevent re or electric shock.
AC/N (White)
AC/L (Black)
V+ (Red)
V− (Blue)
120-277VAC~
50/60 Hz
To Low Voltage
LED Load
V+ (Purple)
V− (Gray)
To 0-10V
Control/
Dimmer
Aach ground wire to mounng
hole or juncon box chassis.
Quick Specs
Installation
Wiring Connections
WARNING
Shock Hazard. May result in serious injury or death.
Turn o power at circuit breaker before installing this product.
Included Models DI-DM-12V60W-0-10V DI-DM-24V100W-0-10V