Manual
1.877.817.6028
www.DiodeLED.com
INSTALLATION GUIDE
info@DiodeLED.com www.DiodeLED.com
5 OF 5
DMX WIFI WALL MOUNT ZONE LED CONTROLLER
®
Visit the online product page at www.diodeled.com for addional product specicaons & warranty informaon.
• DMX WIFI WALL MOUNT ZONE LED CONTROLLER Specicaon Sheet
For full specicaons.
• Voltage Drop Charts
Use to specify appropriate wire gauge for installaon. Available at the ‘Tools & Resources’ page at www.DiodeLED.com.
Additional Resources
QUESTIONS?
Visit www.DiodeLED.com or contact Customer Support at info@DiodeLED.com
or 1.877.817.6028 Monday through Friday, 7:00am - 5:00pm PST.
Troubleshooting
For thorough troubleshoong of LED strip light and xtures, see LED xture installaon guides.
LED xtures not responding to touch
1. Ensure the blue indicator light is on by pressing ‘Power.’ A red indicator signies the device is o. The blue indicator light will blink rapidly when
pressing/holding any key on the touch pad.
2. Ensure the appropriate zone number was pressed prior to controlling the DMX decoder/xture. For example, if you know the xture is addressed
to zone 1, press ‘1’ prior to controlling.
3. Ensure the individual zone has not been turned o. Long pressing zones 1-4 will turn the specic zone ON/OFF. Addionally, long pressing R, G, B,
W will increase/decrease individual brightness and short pressing will turn R, G, B, W ON/OFF.
4. Ensure the DMX decoder/xture is addressed properly. For example, address ‘001’ will respond to zone 1 of the controller. See ‘Seng the DMX
Address’ for addional addressing informaon.
LED xture responding incorrectly
Ensure all wiring connecons are correct. Reversing the Data + and Data - will cause lights to icker and not respond to controller.
5. Check power connecons of all components (drivers, DMX decoders/xtures, DMX controller).
6. DMX Data connecons - See ‘Pinout Connecon Guide’ and ‘System Diagram’ for RJ45 hard-wiring connecons.
7. DMX decoder PWM output connecons – See ‘System Diagram’ for CH 1-4 connecons.
IG061814-1.2