Owner manual
INSTALLATION GUIDE
INFINILINE™ 120V LED STRIP LIGHT
1 of 2
Do not bend LED strip light
on a horizontal plane.
Do not fold or crease
LED strip light.
Do not bend LED strip light to a
diameter less than 1.5 inches.
Do not put excessive pressure on surface of
strip light (e.g. glass/acrylic panes etc.).
1.5 in.
Do not cover strip light with any materials.
Do not cut off or modify the strip light or aached
AC cord that provides power to the strip light.
Do not power strip light while
aached to spool or ghtly coiled.
IMPORTANT SAFETY INSTRUCTIONS.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS. SAVE THESE INSTRUCTIONS.
• Install in accordance with the Naonal Electric Code and local regulaons.
• This product is intended to be installed and serviced by a qualied,
licensed electrician.
• This product must be powered with a GFCI (Ground Fault Circuit
Interrupter) protected circuit when installed in wet locaons or outdoors.
• Do not cover strip light as covering may cause the strip light to overheat,
melt, or ignite.
• Do not operate strip light while aached to plasc spool or ghtly coiled.
Excess heat may melt the spool and/or cause damage to the tape.
• Do not puncture, cut, shorten, or splice (hard wire) strip light. Doing so
causes risk of electric shock and will void the ETL cercaon.
• This product and aached AC chord are not rated for in-wall installaon.
Do not route the AC cord or strip light through walls, doors, windows or
any part of a building structure.
• Do not use if there is any damage to the strip light or AC cord insulaon.
Inspect periodically.
• Do not submerge strip light in liquids, or use the product in the vicinity of
standing water or other liquids.
• Secure this strip light using only mounng clips provided. Do not secure
with staples, nails, its AC cord, or like means that may damage the
insulaon or permanently aach the xture to a building structure.
• Strip light must be handled with care. Excessive handling, bending, and
pressure may damage the product. Do not subject exible lighng to
connuous exing.
• This product has an aached polarized AC plug (one blade wider than the
other) as a feature to reduce the risk of electric shock. This AC plug will
only t into a polarized electrical receptacle. Do not modify the AC plug in
any way. Contact a qualied, licensed electrician if the AC plug does not
t in the electrical receptacle.
• Do not exceed 164 . series runs (for extendable units).
• This product is not dimmable.
• Do not aempt to x product in the eld.
Input Voltage
110-120VAC~ at 50/60Hz
Ambient Temp † -14 ~ +122°F (-10 ~ +50°C)
Environment Outdoor / wet locaon / IP44
†
Do not install product in an environment outside the listed ambient temperature. Ensure adequate airow and heatsinking is considered when
mounng/installing.
For full specicaons, see the ‘Specicaon Sheet’ at the online product page.
Quick Specs
Dimmable No.
Field-Cuable No.
Max Run
See packaging label for run lengths.
This strip light is not rated as eld-cuable.
IG-040214-1.2