User guide

INSTALLATION GUIDE
Use a ruler and pencil to draw
a guiding edge. Mark where the
beginning edge of the channel
will be installed.
Mark holes where the mounng clip
will be fastened. Fasten two clips
per channel, each 1/4 distance the
full length of the channel from each
end. E.g. if the channel is 40 in. long,
mount each clip 10 in. from each end.
Fasten the mounng clips with an
electric drill and mounng screws.
Use applicable screw anchors if
required for installaon.
Hold the channel up to the guide
and mounng clip. Mark the channel
where the top edge of the mounng
clip will be located.
Screw the allen hardware into the
vercal bracket (prongs of stopper
facing down) with a #2 allen wrench.
Slide the vercal bracket into the chan-
nel and ghten with the allen wrench.
Ensure the boom edge of the allen
hardware meets the mark previously
noted on the channel.
Fasten the channel to the mounng
clip on the vercal surface with the
vercal bracket resng above the
mounng clip.
CHROMAPATH™ VERTICAL BRACKET
Page 1 of 1
1 2 3
4
5
6 7
V1.0