Owner's manual

IG051514-1.0
1.877.817.6028
www.DiodeLED.com
INSTALLATION GUIDE
®
[e-mail] www.DiodeLED.com
1 OF 3
RGB WALL MOUNT COLOR CONTROLLER
• Install in accordance with the Naonal Electric Code, and local
regulaons.
• This product is intended to be installed and serviced by a qualied,
licensed electrician.
• Do not connect directly to high voltage 120V~277V power. Install with
a compable Class 2 constant voltage LED driver (power supply).
• Only install compable LED drivers and xtures. Contact technical
support or visit the product page for compable products.
• This product is rated for indoor installaon and is not protected against
moisture.
• Proper heat dissipaon will prolong the working lifespan of this product.
Install in a well-venlated area free from explosive gases and vapors.
• Ensure applicable wire is installed between driver, xture, and any
controls in between. When choosing wire, factor in voltage drop,
amperage rang, and type (in-wall rated, wet locaon rated, etc.).
Inadequate wire installaon could overhead wires, and cause a re.
• Do not modify or disassemble this product beyond instrucons or the
warranty will be void.
Safety & Warnings
Prior to installaon, verify all components are a compable system. Congure and pre-test your LED system prior to permanent installaon to ensure all
components are operang correctly. Install in accordance with the NEC and local regulaons.
Installation
Quick Specs
Ambient Temperature † -4° ~ 122°F (-20° ~ 50°C)
Transming Distance 130 .
Control Type
Pulse Width Modulaon (PWM).
3-channel RGB xtures.
Input / Output Voltage 12-24VDC constant voltage
Max Current Load 3A x 3CH Max 9A
Max Output Power 108W/216W (12V/24V)
Environment Indoor / dry locaon
† Do not install product in an environment outside the listed ambient
temperature.
Turn OFF High Voltage AC Power at the main breaker.
Determine Locaons to Install 3 Main Components.
Refer to the ‘System Diagrams.’
Mount RGB Receiver to Surface. See ‘Wiring Connecons’, use
applicable screws.
Aach Lighng Load and Driver. Only use copper wiring.
Reference ‘Wiring Connecons’ located further in guide for
visual. Use a mini athead screwdriver for aaching wires to
terminal ports. Terminals t up to 12AWG solid-core copper wire.
Verify a compable constant voltage driver is installed.
Install Addional Components, Verify Connecons, and Turn
Main Power ON at Breaker.
1
ON
OFFOFFOFF
ONON
OFFOFF
ONON
2
1) Driver 2) RGB Color
Controller
3) Fixture
Ensure applicable wire is installed between driver, xture, and any
controls in between. When choosing wire, factor in voltage drop,
amperage rang, and type (in-wall rated, wet locaon rated, etc.).
3
4
5
ON
OFFOFFOFF
ONON
OFFOFF
ONON
If system remains unresponsive or is working improperly, turn OFF
main power at breaker and verify all connecons. Review the ‘Wiring
Connecons.’
DO NOT CONNECT DIRECTLY TO HIGH VOLTAGE POWER!
Read all warnings and installaon instrucons thoroughly.
WARNING
WARNING
Shock Hazard. May result in serious injury or death.
DO NOT CONNECT
TO HIGH VOLTAGE
Dry Location Only
12V
DC
24V
DC