DIODOR LED POWERHOUSE Diodor Pro 120W / 200W LED Floodlights Models: DIO-FL120W-WM & DIO-FL200W-WM Installation & operating instructions
Diodor LED Powerhouse – INSTALLATION AND OPERATING INSTRUCTIONS The DIODOR LED Powerhouse floodlight a high-powered, professional LED floodlight which is suitable for use outdoors in a range of commercial applications including lighting perimeters, car parks, garden areas and outside warehouse facilities. The unit requires connection to a 230 AC 50Hz mains electricity supply. 1.
2. WIRING REQUIREMENTS • The unit requires connection to a 230 AC 50Hz mains electricity supply. • It is recommended that the unit is connected to the lighting circuit via a 5 amp fused spur and using Twin & Earth 2-Core round flexible cable of at least 1mm2 gauge (waterproof cable should be used for outdoor installations). • It is also advisable to install a single pole wall switch to allow easy control of the floodlight [Fig. 1]. 3.
3.2. OPTION 2: ATTACHING THE Diodor LED Powerhouse VIA THE PIPE BRACKET If attaching the Powerhouse to a pipe or post using the pipe bracket, first ensure the pole is strong enough to support the weight of the Powerhouse then proceed as follows: • Establish the correct position for the Mightylite Pro on the pipe ensuring the wires can easily reach the unit. • Position the pipe bracket and U bracket around the pipe and secure using appropriate nuts bolts and washers (included), as shown in [Fig.5].
9: 2 NEUTR NEUTR Note: A separate switch is used to control each of the four LED arrays within one or more Powerhouse units. Diagram shows 2 units wired together so that both can operate at 25%, 50%, 75% or 100% light level dependent upon switching. 5. AFTER CONNECTING POWER SUPPLY • After the connections have been secured, the floodlight front (Connection Box front) should be fastened to the Connection Box using the 4 Connection Box Screws.
. TECHNICAL SPECIFICATION Ref: Description: Fascia: DIO-FL120W-WM DIODOR Powerhouse120W Floodlight DIO-FL200W-WM DIODOR Powerhouse 200W Floodlight Matt black polycarbonate Matt black polycarbonate Matt black aluminium Matt black aluminium Frosted Frosted Wattage: 120W 200W Lumens generated: 12000 17000 Voltage: 80 -280V 80 -280V LED array: 96 LEDs 168 LEDs Backplate: Lens: Power factor: >0.9 >0.9 Efficiency: <80% <80% ANSI 5700K ANSI 5700K Colour temperature: Max.