Instruction Manual

14
Securing the Child
1) Make sure booster seat is properly positioned and installed on
vehicle seat as per the instructions in pages 12–13.
2) Properly position child: sitting upright and all the way back in
the booster seat.
3) Make sure booster seat backrest width is adjusted to
narrowest width setting that comfortably ts child (see page 11).
4) Raise the headrest to access red
upper belt guides. A Feed the diagonal
portion of the seatbelt through the guide
on the side opposite the seatbelt buckle.
5) Fasten seatbelt across child: Lap
portion of seatbelt should rest within
both red lower belt guides. Diagonal
shoulder portion should route inside
the red lower belt guide closest to the
buckle and over child’s shoulder.
6) Adjust headrest (page 11) to proper
height: Upper shoulder guide should be
slightly above (at least 1 cm) the child’s
shoulders.
WARNING: If headrest is adjusted to maximum
height and child’s shoulder height is closer than 1 cm
to the upper belt guide, child is too tall and the seat
can only be used a backless booster.