Instruction Manual
16
Backless Booster Seat
While this booster seat is designed to oer advanced side-
impact protection with its backrest section attached, the seat
bottom can also be used alone as a backless booster.
1) Remove seat bottom from backrest section (see page 11).
2) Disengage the two middle elastic straps
and unfold padded fabric ap on back of
seat bottom. A
3) Make sure booster seat is correctly
installed (pages 12–13) and properly
positioned on vehicle seat.
4) Properly position child: sitting upright
and all the way back in the booster seat.
5) Fasten seatbelt across child.
6) Make sure seat belt is not twisted and
lays at across child’s hips, torso and
shoulder.
7) Tighten the seatbelt by pulling the
diagonal shoulder belt portion in the
direction of the arrows.
IMPORTANT: Lap belt position should be as
far forward and as low as possible over child’s
pelvis and contacting upper thighs.
IMPORTANT: Diagonal seat belt portion should route inside the
red lower belt guide closest to the buckle and over child’s shoulder. It
should NOT be touching the neck.
NEVER position the shoulder belt loosely or under the child’s
arm or behind their back.