Instruction Manual
26
Booster
This restraint may also be congured for use as a belt
positioning booster.
WARNING:
• Unsecured objects can become ying hazards and can
cause serious injury in a accident. While not required, it is
strongly recommended to use LATCH and/or tether
anchors in vehicles equipped with such anchorages
• Do NOT use LATCH if installation interferes with vehicle
seat belt.
• Do NOT use as a booster with child under 50 lbs and
under 40" tall and if child’s shoulders are below the 4th
harness position.
• Do NOT use as a booster unless harness straps and
buckle are removed .
• Do NOT use as a booster with only a vehicle lap belt.
• Use as a booster ONLY with lap-shoulder seat belt.
1. Remove buckle (page 37) and both harness straps
(page 43)
2. Place restraint in proper seating location, at on vehicle
seat bottom and touching vehicle seat back.
3. If available, secure restraint with LATCH (page 20) and/
or top tether (page 30)
4. Properly position child in restraint: sitting upright and
all the way back in restraint.
5. Fasten seatbelt across child: lap portion of seatbelt
should rest within both lower belt guides with buckle
located on the outside of the restraint (Fig. 1)