Instruction Manual

Rear-Facing LATCH Installation

WARNING:

• You must use restraint rear-facing if child is less than 1

year and weighs less than 20 lbs.

• Detachable base must be used with rear-facing restraint.

• Do NOT use SafeStop with rear-facing child.

• Do not install by this method for a child weighing more

than 35 lbs.

• See page 42 for LATCH connector instructions.

Fig. 1 shows a typical rear-facing installation with LATCH.

1. Conrm detachable base is securely attached to

restraint bottom (see page 13).

2. Conrm vehicle seating location has its own LATCH

anchors (see vehicle owner’s manual). If it does not, you

must use vehicle seat belt for installation (see pages 16

and 18).

3. Locate LATCH belt secured in storage compartment on

restraint back. Press red release button to remove each

LATCH connector and

webbing. Slide the narrow

LATCH tethering strap out

of plastic strap guides on

side of the seat.

4. Place restraint in proper

rear-facing position:

Restraint bottom and base are both at on the vehicle

seat with front of restraint against the back of that

vehicle seat. (Fig. 1)

Note: It may be necessary to move vehicle front seats

slightly forward to properly t a rear-facing restraint.