Instruction Manual
21
Installation Tip:
Unfasten fabric side panels and
reach behind restraint cover for
easy access to belt path. (Fig. 3)
5. Conrm LATCH belt lays at
and is not twisted. Attach
each connector to the
LATCH anchor closest to
each side of the restraint.
(Fig. 4)
LATCH connector will ‘click’
to conrm attachment to
anchor.
6. Position connector mecha-
nisms behind the restraint
(Fig. 5A).
7. Pull loose end of LATCH
strap through back of
restraint (Fig. 5 and Fig. 6).
Placing left knee inside
restraint at the very back
and leaning left shoulder
against restraint seat back
(to force restraint into
vehicle seat), pull strap
upwards with both hands
towards vehicle ceiling until
tight. (Fig. 6)
8. Try to wiggle restraint to
conrm security of installa-
tion, then repeat Step 7.
Vehicle cushions should
compress where there is
contact with restraint.
CHECK LIST:
Conrm restraint is
properly positioned.
Conrm LATCH belt is tight
and that connections to
approved LATCH anchors are secure.
Conrm restraint is stable (see page 25).
Removal:
Press red release button on back of each LATCH connector.
Disconnect top tether. Properly store LATCH belt and top
tether.
3
4
5
6
A