User Manual
9
Blow through one of the lines to en-
sure the fuel lines have not become kinked
inside the fuel tank compartment. Air
should ow through easily.
INSTALLING THE FUSELAGE SERVOS.
Because the size of servos dier, you may
need to adjust the size of the precut opening
in the mount. e notch in the sides of the
mount allow the servo lead to pass through.
1) Install the rubber grommets and brass
collets onto the throttle servo. Test t the
servo into the aileron servo mount.
2) Secure the servos with the screws provid-
ed with your radio system.
THROTTLE SERVO ARM
INSTALLATION.
Install adjustable servo connector in the
servo arm as same as picture below:
INSTALLING THE SWITCH.
Install the switch into the precut hole in the
side, in the fuselage.
Adjustable servo
connector.
Servo arm.
Loctile
secure.
3/32” Hole.
Rudder servo.
Elevator servo.
Throttle servo.
Rudder servo.
Elevator servo.
Throttle servo arn.
.
Trim and cut.