Instructions / Assembly

25en
10. Photo Eyes
10.1. Installation Step 12 - Install the Photo
Eyes
WARNING
There is a possible risk of injury or death through electri-
cal voltage if you do not observe and comply with the fol-
lowing information.
Prior to installation, ensure that there is no voltage present to
the opener.
Do only connect the photo eyes to the opener terminals in the
control housing.
Some local construction ordinances do not allow an on-
wall installation of wires. Please check with your local
building inspector.
10.2. Function
STOP
The photo eye set safeguards the door. If the photo eyes are
breached, the door’s closing procedure is stopped. If the door
stops during closing because of the photo eyes, it subse-
quently opens completely.
The opener only functions with the connected photo eye set.
Scope of supply- see page 11
10.3. Installation requirements and
dimensions
WARNING
There is a possible risk of injury or death if the fol-
lowing conditions are not fulfilled. The photo eye
set may only be installed when the following instal-
lation requirements and installation dimensions are
given.
Never run the photo eye wires next to an on-site power wire
as this can cause malfunctions in the opener controls.
Select an installation location for the photo eyes inside the
garage and outside of the range of motion of the door and the
opener mechanics.