Instructions / Assembly

33en
Learning the radio code
1. Press the learn button (1) once on the control housing.
 The LED (Radio) is solid.
2. Press a desired transmitter button (2).
The LED (Radio) flashes briefly.
 If the LED (Radio) lights up for a second, the trans-
mitter has been learned.
Programming additional transmitters. Repeat the above
steps. A maximum of 20 button/storage locations for each
radio receiver are available.
If no radio code is received within 10 seconds, the learn-
ing process is interrupted and has to be started again if
nece ssary.
Light function
In order to switch the light on the opener on or off separately
using the transmitter, a second transmitter button function
has to be “learned in”.
Radio
Power
Status
Safety
Comman
d
Reset
2
1
14
15
16
Radi
o
Po
we
r
St
at
us
Safety
Command
R
eset
Lear
n
Lear
n
13
3
4
5
6
2
1
1
Learn
1. Press the learn button (1) on the control housing two
times. The LED (Radio) blinks briefly.
2. Press the desired transmitter button (2).
 When the LED (Radio) lights up for a second, the
transmitter has been learned.
Other functions
Depending on the DIP switch settings, other functions such
as “partial opening” or “defined operation” can be “learned in”
for a second transmitter button in the same way. See chapter
“Settings”.
Deleting a previously learned radio code
2
1
14
15
16
Radio
Po
we
r
St
atus
Safety
Command
Reset
Lear
n
Lear
n
13
3
4
5
6
Radio
Power
Status
Safety
Command
R eset
LearnLearn
11
1. Press the learn button (1) on the control housing for at
least five seconds until the LED (Radio) blinks slowly.
2. Press the desired transmitter button. The LED (Radio)
lights up for one second.
 When the LED (Radio) turns off, the radio code of
this transmitter button is deleted.
12. Initial operation