Manual

Pro9F 9000 lbs. Floor Plate Lift IN50019 Rev. C 03/30/2009
3
CAUTION!!
ENSURE THAT ALL CABLE SHEAVES, BEARINGS, AND SHAFTS ARE SUFFICIENTLY
LUBRICATED. ALSO, THE CORNERS OF EACH COLUMN SHOULD BE LIGHTLY
GREASED WITH QUALITY LITHIUM GREASE PRIOR TO OPERATING THE LIFT.
LUBRICATE ALL ON AN ANNUAL BASIS.
Motors and all electrical components are not sealed against the weather and moisture.
Install this lift in a protected indoor location. Failure by the owner to provide the
recommended shelter could result in unsatisfactory lift performance, property damage,
or personal injury.
GENERAL LIFT INFORMATION and FEATURES
FLOOR PLATE MODEL
The following lift is a 2-Column Hydraulic, leaf chain driven unit.
The name/model numbers are designated below:
• Floor Plate: Pro9F 2-Column Lift, Floor Plate Lift type, 9000 lbs. Capacity, Symmetric
Swing Arm set up.
This lift is an 9,000 lb. capacity, 2-Post Lift. The locking latch system is very similar to an
extension ladder. The locking latch is in contact with the latch rack. As the lift rises the
locking latch drops into place. The locking latch engages the latch rack in 3” increments
starting at about 16” from the ground. The locking latches must be manually disengaged
for the lift to lower. The locking latch is released by pulling the Release Cable, first
raising the lift to get the latch up off the latch rack. Once the raise button is pressed, the
latch will automatically reengage after approximately 3" of travel. Heavy bearings and
heavy-duty leaf chains are used throughout the lift. The work is done with the heavy-duty
chain connected to a 2-1/2" cylinder, driven by an electric / hydraulic pump.