Instructions / Assembly

F
F
i
i
r
r
e
e
P
P
i
i
t
t
O
O
w
w
n
n
e
e
r
r
'
'
s
s
M
M
a
a
n
n
u
u
a
a
l
l
For a safe and pleasurable heating experience, perform this check before each use
Before Operating：
1. I am familiar with entire owner's manual and
understand all precautions noted
2. All components are properly assembled, intact
and operable
3. No alterations have been made
4. All gas connections are secure and do not leak
5. Wind velocity is below 10 mph
6. Unit will operate at reduced efficiency below
40 °P4.44 °C
7. Fire pit is outdoors (outside any enclosure)
8. There is adequate fresh air ventilation. Do not
use this appliance if any part has been under
water. Immediately call a qualified service
technician to inspect the appliance and to
replace any part of the control system and gas
control which has been under water
9. Fire pit is away from gasoline or other
flammable liquids or vapors
10. Fire pit is away from windows, air intake
openings, sprinklers and other water sources
11. Fire pit is at least 36 in. on rear and at least 36
in. on sides from combustible materials
12. Fire pit is on a hard and level surface
13. There are no signs of spider or insect nests
14. All burner passages are clear
15. All air circulation passages are clear
16. Children and adults should be alerted to the
hazards of high surface temperatures and
should stay away to avoid bums or clothing
ignition.
17. Young children should be carefully supervised
when they are in the area of the fire pit.
18. Clothing or other protective material should
not be hung from the fire pit, or placed on or
near the fire pit
19. Any guard or other protective device removed
for servicing the fire pit must be replaced prior
to operating the fire pit
20. Installation and repair should be done by a
qualified service person. The fire pit should be
inspected before use and at least annually by a
qualified service person
21. More frequent cleaning may be required as
necessary. It is imperative that control
compartment, burner and circulating air
passageways of the fire pit be kept clean
After Operation：
1. Gas control is in OFF position
2. Gas Tank valve is OFF
3. Disconnect Gas line
4. After each use, replace cap on tank
PREPARATION ：
Before beginning assembly of product, make sure
all parts are present Compare parts with package
contents list and hardware contents above. If any
part is missing or damaged, do not attempt to
assemble the product Contact customer service
for replacement parts.
Estimated Assembly Time： 15 Minutes
Tools Required for Assembly (not included
Phillips screwdriver medium blade. Leak Detection
Solution.