Use and Care Manual

DB1930FD

The ultimate upgrade made from Silicon Nitride, robust and durable. This direct drop in upgrade replaces

Hayward FDXLIGN1930

• 3 year warranty

• Simple to fit

• Direct drop in replacement

• Used in following

• Replaces the following Part Number; Hayward FDXLIGN1930

Replaces

Hayward FDXLIGN1930

Used In

Hayward Universal H-Series

H150FDN

H150FDP

H200FDN

H200FDP

H250FDN

H250FDP

H300FDN

H300FDP

H350FDN

H350FDP

H400FDN

H400FDP

Warranty

Direct Brand will, during the period of warranty from the date of purchase, replace the igniter, free of

charge, where it is faulty due to defective materials or workmanship.

This warranty is only valid in the United States of America and Canada, 3 years from date of purchase,

and on production of the original sales receipt or invoice together with the faulty product.

PAGE 1
DB1930FD The ultimate upgrade made from Silicon Nitride, robust and durable.
PAGE 2
You may not claim under this warranty when the igniter is damaged as a result of accident, commercial use, fair wear and tear or misuse (including, without limitation failure to use the igniter for its normal purpose, in accordance with the instructions or use in a manner inconsistent with applicable local technical or safety standards). Any adaptation or adjustment to, or alteration of, the igniter carried out for any reason, whether properly carried out or not.
PAGE 3
Commissioning 1. Turn on the gas supply and electrical supply to the appliance. 2. Set the room thermostat for heat. 3. Test furnace for proper ignition and operation. 4. Verify that the Power‐On LED, on the power module, is on during the Glo‐Stix™ igniter warmup. 5. During igniter warm‐up, using a true RMS voltmeter, measure the voltage across the igniter. Voltage should be between 50 VAC and 120 VAC. 6. Make sure the Glo‐Stix™ igniter does not remain energized in the flame for more than a few seconds. 7.