Use and Care Manual

DB6015

The ultimate upgrade made from Silicon Nitride, robust and durable. This direct drop in upgrade replaces AO

Smith 100110355

• 3 year warranty

• Simple to fit

• Direct drop in replacement

• Used in following

• Replaces the following Part Number; AO Smith 10011035

Replaces

100110355

9005256015

183267

1835273-000

Used in

FPSH-40/50 FPST-50

Warranty

Direct Brand will, during the period of warranty from the date of purchase, replace the igniter, free of

charge, where it is faulty due to defective materials or workmanship.

This warranty is only valid in the United States of America and Canada, 3 years from date of purchase,

and on production of the original sales receipt or invoice together with the faulty product.

You may not claim under this warranty when the igniter is damaged as a result of accident,

commercial use, fair wear and tear or misuse (including, without limitation failure to use the igniter

for its normal purpose, in accordance with the instructions or use in a manner inconsistent with

applicable local technical or safety standards).

Any adaptation or adjustment to, or alteration of, the igniter carried out for any reason, whether

properly carried out or not. Where permitted under applicable law, this warranty will be your sole and

exclusive remedy for breach of any warranty, guarantee or condition, express or implied, in respect of

PAGE 1
DB6015 The ultimate upgrade made from Silicon Nitride, robust and durable.
PAGE 2
this product and neither Direct Brand nor their suppliers will be liable for any incidental or consequential loss or damage. Fitting Instructions Fitting Instructions Please read all these instructions to the end carefully before beginning installation. 1. Identify which type of hot surface igniter is inside your appliance. 2. Unplug your existing igniter, retaining all fittings, and match it up with diagrams above (this can also be done by comparing the top end view of the base type). 3.
PAGE 3
2. Set the room thermostat for heat. 3. Test furnace for proper ignition and operation. 4. Verify that the Power‐On LED, on the power module, is on during the Glo‐Stix™ igniter warmup. 5. During igniter warm‐up, using a true RMS voltmeter, measure the voltage across the igniter. Voltage should be between 50 VAC and 120 VAC. 6. Make sure the Glo‐Stix™ igniter does not remain energized in the flame for more than a few seconds. 7. Replace the burner compartment door. 8.