Use and Care Manual

DB9800

The ultimate upgrade made from Silicon Nitride, robust and durable. This direct drop in upgrade replaces

Zodiac RO449800

• 3 year warranty

• Simple to fit

• Direct drop in replacement

• Used in following

• Replaces the following Part Number; Zodiac R0449800

Replaces

Zodiac R0449800

Used In

Zodiac Jandy Lite2 Pool and Spa Heater model

LJ 125

LJ 175

LJ 250

LJ 325

LJ 400

Warranty

Direct Brand will, during the period of warranty from the date of purchase, replace the igniter, free of

charge, where it is faulty due to defective materials or workmanship.

This warranty is only valid in the United States of America and Canada, 3 years from date of purchase,

and on production of the original sales receipt or invoice together with the faulty product.

You may not claim under this warranty when the igniter is damaged as a result of accident,

commercial use, fair wear and tear or misuse (including, without limitation failure to use the igniter

PAGE 1
DB9800 The ultimate upgrade made from Silicon Nitride, robust and durable.
PAGE 2
for its normal purpose, in accordance with the instructions or use in a manner inconsistent with applicable local technical or safety standards). Any adaptation or adjustment to, or alteration of, the igniter carried out for any reason, whether properly carried out or not.
PAGE 3
Commissioning 1. Turn on the gas supply and electrical supply to the appliance. 2. Set the room thermostat for heat. 3. Test furnace for proper ignition and operation. 4. Verify that the Power‐On LED, on the power module, is on during the Glo‐Stix™ igniter warmup. 5. During igniter warm‐up, using a true RMS voltmeter, measure the voltage across the igniter. Voltage should be between 50 VAC and 120 VAC. 6. Make sure the Glo‐Stix™ igniter does not remain energized in the flame for more than a few seconds. 7.