BLADE120v INSTALLATION HSIURK120vB p p Fitting Instructions Commissioning For Assembly view Igniter being replaced from the top with element facing down p p p p p p p Replacement List Igniter Specification Hazards Warnings Warranty
The heating element (illustrated right) is Silicon Nitride a unique all ceramic (Si3N4) product. It heating element uses complex multi-layer moulding and sintering techniques. The heating element is moulded in one Bracket stainlesscasting machines; the using injection steel 304 part is then sintered by air pressure. Bright finish Ring attachments are used for electrical connections, then vacuum brazed.
First edition published in USA by Direct Brand Limited, 2015 11b Depot Street South Grafton, MA 01560 Copyright © Direct Brand Limited 2015 The rights of Direct Brand Limited of this work have been asserted by them in accordance with the Copyright, Designs and Patents Act 1988. Part number SNGSHSI/120vB/Install Glo-Stix® is a registered trademark Because of continued improvement to the product, Direct Brand Limited reserve the right to alter specification.
Warranty Direct Brand Limited will, during the period of warranty, from the date of purchase, replace the igniter free of charge, where it is faulty due to defective materials or workmanship. This warranty is in addition to your statutory consumer rights (under applicable law) and does not affect them in any way.