OWNER’S MANUAL model CSX-T
CONGRATULATIONS Congratulations for choosing a Directed SX series neodymium component speaker system from Directed Electronics. Directed Electronics has been the industry leader in high-quality automotive security and audio equipment since 1990, and with the introduction of the SX line of high-quality loudspeakers for the automobile, Directed continues to set new standards of performance, reliability, and affordability in the mobile electronics industry.
LIMITED TWO-YEAR CONSUMER WARRANTY Directed Electronics, Inc. promises to the original purchaser, to replace this product should it prove to be defective in workmanship or material under normal use, for a period of two years from the date of purchase from the dealer as indicated by the date code marking of the product PROVIDED the product was installed by an authorized Directed dealer.
FEATURES Tweeter New hotter 19mm ferrofluid cooled silk dome tweeters with neodymium magnet. 2 Angled and 2 non-angled 19mm flush and surface mount tweeter housings provided. Crossover assemblies for each tweeter. Butyl rubber segments provided to facilitate grill mounting, sealing air leaks, or damping unwanted vibration. WARNING High-powered car audio systems may produce sound pressure levels that exceed the threshold at which hearing loss may result.
INSTALLATION PRECAUTIONS The Directed SX series neodymium separates are designed for installation into factory speaker locations, custom mounting enclosures or any flat mounting surface inside the vehicle. The following precautions and instructions cover the basic and most common types of installation. Check behind panels for clearance of metal brackets, hoses, and wire harnesses before making any cuts.
TWEETER INSTALLATION Review the Installation Precautions section of this guide before proceeding. 5. Remove the tweeter grill, and the remove the tweeter from the surface mount housing using the tweeter tool (turn CW). Insert the proper length machine bolt through the housing and connect to the metal mounting bracket. (See Figure 2.) Flush Mounting into Mounted Panels Note: Use either the standard mount housing or the angled mount housing. 1.
route the speaker wire from the crossover through the grommet. Tweeter Surface Mounting Note: Use either the standard mount housing or the angled mount housing. 5. After removing the surface mount tweeter assembly, route the tweeter wires through the larger hole in the housing and connect to the speaker wires from the crossover. (See Figure 4.) 1. Determine the tweeter mounting location, then route the wires from the crossover to the tweeter location. 2.
SPECIFICATIONS Model CSX-T Fs Efficiency (1W/1M) Magnet Diameter Voice Coil Diameter Mounting Hole Diameter Crossover 1.
Directed Electronics, Inc. Vista, California 92081 www.directed.com The company behind this system is Directed Electronics, Inc. Since its inception, Directed has had one purpose, to provide customers with the finest vehicle security, car stereo products, rear seat entertainment, and accessories available. The recipient of more than 20 patents in the field of advanced electronic technology, Directed is ISO 9001 registered.
