Installation guide

2002

Directed Electronics, Inc.

TToo pprrooggrraamm tthhee lleeaarrnn rroouuttiinnee::

KKeeyy..

Turn the ignition on and then back off.

CChhoooossee..

Within 10 seconds, press and release the Valet®/Program switch

the number of times corresponding to the feature number you want to

program. (See Feature Menus.) Once the Valet®/Program switch has

been pressed and released the desired number of times, press it once more

and hold it. After a second, the LED will flash and the horn will honk to

indicate which feature you have accessed.

TTrraannssmmiitt..

The transmitter is used to select the desired setting. As shipped,

the unit is configured to the LED ON settings. These are the default

settings. Pressing the lock button will set it to the LED ON setting. The

LED will light solid (stop flashing) to indicate the setting. The horn will

honk once (if connected). Pressing the unlock button will change the

setting to the LED OFF setting. The LED will go out indicating the

change and the horn will honk twice (if connected).

4. Release. The Valet®/Program switch can now be released.

For example, to program the arming mode from active to passive, within 10 seconds of turning the

ignition off, and press and release the Valet/Program switch once. Then press it again and hold it.

The LED will flash in groups of one and the horn will honk once (if connected). While holding the

Valet®/Program switch, press the unlock button. The LED will stop flashing and go out. The horn

will honk twice if connected. Passive arming is now programmed. If that was not the desired setting,

without releasing the Valet®/Program switch, press the lock button. The LED will light solid and

the horn will honk once if connected. Active arming is now programmed. Release the

Valet®/Program switch after the selection has been made.

You can advance from feature to feature by pressing and releasing the Valet®/Program switch the

number of times necessary to get from the feature you just programmed to the feature you wish to

access. For example, if you just programmed Feature 2 and you next want to program Feature 3 to

off, release the Valet/Program switch. Press and release it once to advance from Feature 2 to Feature

3. Then press it once more and hold it. The LED will flash in groups of three and the horn will

honk three times (if connected) to confirm that you have accessed Feature 3.