Installation guide

©
2002 Directed Electronics, Inc. 11
The learn routine will be exited if:
➤ The ignition is turned on.
➤ The Valet/Program switch is pressed too many times.
➤ More than 15 seconds elapses between programming steps.
One long horn honk (if connected) indicates that the Learn Routine has been exited.
System Features Menus
Feature Descriptions
The features of the system are described below. Features that have additional settings that can be
selected only when programming with the 998T Bitwriter are indicated by the following
icon:
1 ACTIVE/PASSIVE ARMING: When active arming is selected, the starter kill will arm (if
connected) only when the transmitter is used. When set to passive arming, the starter kill will arm
(if connected) 30 seconds after the ignition key is turned off.
2 CHIRPS ON/OFF: This feature controls the chirps that confirm arming and disarming of the
system. A siren or horn must be connected to the H1/10 BROWN wire.
Feature Default LED ON Setting LED OFF Setting
Number (Press Channel 1) (Press Channel 2)
1 Active arming Passive arming
2 Chirps ON Chirps OFF
3 Ignition-controlled door lock ON Ignition-controlled door lock OFF
4 Ignition-controlled door unlock ON Ignition-controlled door unlock OFF
5 Active locking Passive locking
6 Ignition-controlled domelight ON Ignition-controlled domelight OFF
7 0.8 second door lock pulses 3.5 second door lock pulses
8 Double pulse unlock OFF Double pulse unlock ON
9 Security features ON Security features OFF
10 Code Hopping ON Code Hopping OFF