Installation guide

12
©
2002
Directed Electronics, Inc.
3 IGNITION CONTROLLED DOOR LOCK ON/OFF: When turned on, the doors will lock three
seconds after the ignition is turned on.
4 IGNITION CONTROLLED DOOR UNLOCK ON/OFF: When turned on, the doors will
unlock when the ignition is turned off.
5 ACTIVE/PASSIVE LOCKING: If passive arming is selected in Feature 1, then the system can be
programmed to either lock the doors when passive arming occurs, or only lock the doors when the
system is armed with a transmitter. Active locking means the doors will not lock when the system
passively arms. Passive locking means that the doors will lock whenever the system passively arms
the starter kill (if connected).
6 IGNITION CONTROLLED DOMELIGHT: If turned on, the system will turn on the domelight
for 30 seconds when the ignition is turned off. The domelight supervision output (H1/4) wire must
be connected to an optional relay as described in the Primary Harness Wire Connection Guide.
7 DOOR LOCK PULSE DURATION: Some European vehicles, such as Mercedes-Benz and Audi,
require longer lock and unlock pulses to operate the vacuum pump. Programming the system to
provide 3.5 second pulses will accommodate the door lock interface in these vehicles. The default
setting is 0.8 second door lock pulses.
8 DOUBLE PULSE UNLOCK OFF/ON: Some vehicles require two pulses on a single wire to
unlock the doors. When the double pulse unlock feature is turned on, the BLUE H4/C wire will
supply two negative pulses instead of a single pulse. At the same time, the GREEN H4/A wire will
supply two positive pulses instead of a single pulse. This makes it possible to directly interface with
double pulse vehicles without any extra parts.
9 SECURITY FEATURES ON/OFF: In the ON setting the (-) ground-when-armed output will be
active and can be used to operate starter kill. The unit will also trigger a panic sequence if the
ignition is turned on before disarming the system. Turning the security features off will turn off both
the starter kill feature and the triggered sequence with ignition.
10 CODE-HOPPING ON/OFF: The system features Code-Hopping as an option. To use Code-
Hopping technology, this feature must be programmed on.