Installation guide

2002

Directed Electronics, Inc.

Primary Harness (H1) Wire Connection Guide

Primary Harness (H1) Wiring Diagram

The primary harness supplied with this unit is the standard 12-pin harness used by Directed security

systems. Two wires in the plug are not used. The upgrade from this unit to a security system would

simply require unplugging and exchanging control units and connecting the necessary wires to the

vehicle. The functions of all the wires that are used in the primary harness are outlined in the

following wiring diagram and the wire connections are described in the wire connection guides.

___

Primary Harness Wire Descriptions

H1/1 ORANGE (-) Ground-When-Armed Output

This wire supplies a (-) 500 mA ground as long as the system is armed. This output ceases as soon

as the system is disarmed. The orange wire is pre-wired to control the 8618 starter kill relay.

NOTE: if using the H1/1 Orange wire to activate an add-on accessory such as window automation,

pager or voice module a 1Amp diode must be installed to ensure proper operation. Insert the diode

as shown in the following diagram.

RED/WHITE (-) 200 mA Channel 2 Validity Output

RED (+) Constant Power Input

BROWN (-) Horn Honk Output

YELLOW Switched Ignition Input

BLACK (-) Chassis Ground Input

VIOLET No Function

BLUE (-) 200 mA Second Unlock Output

GREEN No Function

BLACK/WHITE (-) 200 mA Domelight Supervision Output

WHITE/BLUE (-) 200 mA Channel 3 Validity Output

WHITE (-) Light Flash Output

ORANGE (-) 500 mA Armed Output

H1/1

H1/2

H1/3

H1/4

H1/5

H1/6

H1/7

H1/8

H1/9

H1/10

H1/11

H1/12