Installation guide

6
©
2002
Directed Electronics, Inc.
H1/6 BLUE (-) 200 mA Second Unlock Output
The H1/6 BLUE output is used for progressive unlock. A progressive unlock system unlocks the
driver's door when the unlock (disarm) button is pressed and unlocks the passenger doors if the
unlock (disarm) button is pressed again within 15 seconds after unlocking the driver's door. The
BLUE wire outputs a low current (-) pulse on the second press of the unlock button of the trans-
mitter. This negative unlock output is used to unlock the passenger doors.
H1/8 BLACK (-) Chassis Ground Connection
Connect this wire to a clean, paint-free sheet metal location (driver kick panel) using a factory bolt
that DOES NOT have any vehicle component grounds attached to it. A screw should only be used
when in conjunction with a two-sided lock washer. Under dash brackets and door sheet metal are
not acceptable ground points. It is recommended that all security components be grounded at the
same location.
H1/9 YELLOW (+) Ignition Input
Connect this wire to an ignition source. This input must show (+)12V with the key in run position
and during cranking. Make sure that this wire cannot be shorted to the chassis at any point. This
wire will trigger the system if the ignition is turned on before the unit is disarmed (doors unlocked
with the remote). It will also honk the vehicle’s horn and flash the parking lights (if connected).