Installation guide

©
2002 Directed Electronics, Inc. 9
Valet/Program Switch, 2-Pin BLUE Plug
The Valet/Program button should be accessible from the driver’s seat. It plugs into the BLUE port
on the side of the unit. Consider how the button will be used before choosing a mounting location.
Check for rear clearance before drilling a 9/32-inch hole and mounting the button.
Programmer Interface, 3-Pin Port
The BLACK three-pin port is provided for programming of the unit. When using the 998T
Bitwriter, it is possible to configure any and all of the programmable functions. For more infor-
mation please refer to the guide packaged with the programmer.
System Features Learn Routine
The System Features Learn Routine dictates how the unit operates. It is possible to access and
change any of the feature settings using the Valet/Program switch. However, this process can be
greatly simplified by using the 998T Bitwriter. Any of the settings can be changed and then assigned
to a particular transmitter, up to four, a feature called Owner Recognition. Each time that particular
transmitter is used to disarm the system, the assigned feature settings will be recalled. Owner
Recognition is only possible when programming the unit via the 998T Bitwriter.
If the system was previously programmed using the 998T Bitwriter, the learn routine may be
locked. If the horn generates one long honk when attempting to program the unit, the learn routine
is locked and must be unlocked using the 998T Bitwriter before proceeding.