Operating instructions

4
N400A 3/01
© 2001 Directed Electronics, Inc.
H1/3 WHITE/BLUE AUXILIARY OUTPUT AND H1/12 RED/WHITE AUXILIARY OUTPUT
The auxiliary outputs of the Car★Com
™
can be used to operate optional low-current relays or accessories. These
outputs can also be connected to a high current device, such as a motor or a solenoid, but only if a relay has
been added. Connecting a high current device to the auxiliary outputs without adding a relay will damage the
Car★Com
™
.
H1/4 BLACK/WHITE, H1/5 GREEN, AND H1/7 VIOLET
No function.
H1/6 BLUE
NOTE: This wire is not used unless utilizing the Dealer Lot Protection Program.
This wire controls the Dealer Lot Protection/user mode feature. To utilize Dealer Lot Protection mode, the H1/6
wire must be grounded to an easily accessible ground location in the vehicle. When dealer lot protection mode
is no longer required, remove the H1/6 wire from ground by cutting the wire to select user mode. (For details on
the Dealer Lot Protection Program, contact Directed Electronics at 1-800-876-0800.)
H1/8 BLACK
Connect this wire to bare metal, preferably with a factory bolt rather that your own screw. (Screws tend to either
strip or loosen with time.) Do not confuse this wire with the small gauge black wire that is pre-wired to the
3-pin plug.
H1/9 YELLOW
No function.