Model 4113 Remote Start Owner’s Guide © 2008 Directed Electronics, Vista, CA G4113L 2008-07
Contents Government Regulations.....................................................................................5 Warning! Safety first..........................................................................................6 What is Included ............................................................................................9 Important Information.........................................................................................9 System Maintenance........................................
Government Regulations This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules.
Warning! Safety first The following safety warnings must be observed at all times: Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. When properly installed, this system can start the vehicle via a command signal from the remote control transmitter. Therefore, never operate the system in an enclosed area or partially enclosed area without ventilation (such as a garage).
After the remote start module has been installed, contact your authorized dealer to have him or her test the remote start module by performing the Safety Check outlined in the product installation guide. If the vehicle starts when performing the Neutral Safety Shutdown Circuit test, the remote start unit has not been properly installed. The remote start module must be removed or the installer must properly reinstall the remote start system so that the vehicle does not start in gear.
What is Included • • • • • • The control module An HX receiver/antenna Two 1-button transmitters (P/N 7111L) A push-button programming switch Your warranty card A shut-down toggle switch Important Information Congratulations on the purchase of your remote start keyless entry system. This system has been designed to provide years of trouble-free operation. By carefully reading this owner’s guide prior to using your system, you will maximize the use of this system and its features.
Using Your System ➢ Unlocking Only after the vehicle is remotely started via the transmitter, press and release the transmitter button for 1 second to unlock the vehicle’s doors. The parking lights will flash and the horn will honk twice to confirm unlock. Note: horn honk is an optional feature. ➢ Car finder Before the vehicle is remotely started via the transmitter, press and hold the transmitter button for 3 seconds to activate the car finder function (parking lights will flash 5 times slowly).
Note: If the ignition is turned on while the vehicle is remote started the doors will not lock until the remote start shuts off. To avoid being locked out of the vehicle, do not turn the ignition on until you are ready to drive the vehicle. ➢ Remote Start This feature allows you to remotely start and run your vehicle for a programmable period of time. This makes it possible to warm up the engine, as well as adjust the interior temperature of the vehicle with the climate control system.
the ON position, the engine will shut down. While the vehicle is running during remote start operation, the system will monitor the vehicle and will automatically shut down the engine if the system receives any of the following shut-down inputs: • • • • • The The The The The brake pedal is pressed. hood is opened. shutdown toggle switch is put into the ON position. pre-programmed run time has elapsed. single button is pressed and held for 3 seconds.
Programming options Programming options control your system's normal operational set-up. Most options do not require additional parts, but some may require installation labor. The following is a list of the programmable options, with the factory settings in bold. • • 12, 24, or 60 minute run time. Your system can be programmed to allow the vehicle to run for 12, 24, or 60 minutes when remote started. Can be set up to minute increments by your installer. Parking lights flashing or constant.
✂ Quick Reference Guide To remote start the vehicle Cut along the dotted line and fold to keep in purse or wallet for a quick and easy reference. • Press and release the transmitter button for 1-second. The parking lights will turn on constant to confirm remote start operation. To shut down remote start • Press and hold the transmitter button for 3 seconds. The parking lights will turn off. Car finder (before remote start) • Press and hold the transmitter button for 3-seconds.
© 2008 Directed Electronics. All rights reserved. ✂ Cut along the dotted line and fold to keep in purse or wallet for a quick and easy reference.
Limited lifetime consumer warranty Directed Electronics.
WITHOUT LIMITATION, LIABILITY FOR THEFT, DAMAGE AND/OR VANDALISM. THIS WARRANTY DOES NOT COVER LABOR COSTS FOR MAINTENANCE, REMOVAL OR REINSTALLATION OF THE UNIT OR ANY CONSEQUENTIAL DAMAGES OF ANY KIND. IN THE EVENT OF A CLAIM OR A DISPUTE INVOLVING DIRECTED OR ITS SUBSIDIARY, THE VENUE SHALL BE SAN DIEGO COUNTY IN THE STATE OF CALIFORNIA. CALIFORNIA STATE LAWS AND APPLICABLE FEDERAL LAWS SHALL APPLY AND GOVERN THE DISPUTE.
The company behind this system is Directed Electronics Since its inception, Directed Electronics has had one purpose, to provide consumers with the finest vehicle security and car stereo products and accessories available. The recipient of nearly 100 patents and Innovations Awards in the field of advanced electronic technology. Directed is ISO 9001 registered. Quality Directed Electronics products are sold and serviced throughout North America and around the world.
