Installation guide

Super Bright LED, 2-pin white plug

The super bright LED operates at 2V DC. Make sure the LED wires are not shorted to ground as the LED will be

damaged. Multiple LED’s can be used, but they must be wired in series. The LED fits into a 9/32 inch mounting

hole. Be sure to check for clearance prior to drilling the mounting hole.

Valet

/Program Switch, 2-pin blue plug

The Valet

/Program switch should be accessible from the driver’s seat. It plugs into the blue port on the side of the

unit. Since the system features Valet

by using the remote transmitter, the switch can be well hidden. Consider how

the switch will be used before choosing a mounting location. Check for rear clearance before drilling a 9/32-inch

hole and mounting the switch.The GRAY wire in the two-pin plug may also be used as a (+) ghost switch input and

can be connected to any (+) switch in the vehicle. (See Feature Descriptions section of this guide.)

Programmer Interface, 3-pin black plug

The black three pin port is provided for personal computer programming of the unit. When using the DEI Bitwriter

(P/N 998T) or optional PC Interface module (P/N 996T) it is possible to configure any and all of the programmable

functions using an IBM-compatible personal computer. For more information please refer to the guide packaged

with the programmer. This port can also be used to interface the Valet

Car

★

Com (DEI P/N 820T) with the secu-

rity system.

There is a dual-stage shock sensor inside the control unit. Adjustments are made via the rotary control as indicated

in the diagram. Since the shock sensor does not work well when mounted firmly to metal, we do not recommend

screwing down the control module. The full trigger of the on-board shock sensor reports Zone 2. See the Table of

Zones section of this guide.

NOTE: When adjusting the sensor, it must be in the same mounting location that it will be after the

installation is completed. Adjusting the sensor and then relocating the module requires readjustment.

The four-pin shock sensor harness is optional, and is not included with this unit.

RED, BLACK

These wires supply constant 12 volts and ground to the optional sensor.

BLUE, GREEN These wires are multiplex inputs. If a (-) input of less than 0.8 seconds is supplied to either wire,

the Warn-Away response will occur. A (-) input of longer than 0.8 seconds to either wire will initiate the triggered

sequence and report Zone 4.

OPTIONAL FOUR-PIN SHOCK SENSOR HARNESS

ON-BOARD DUAL STAGE SHOCK SENSOR

PLUG-IN HARNESSES