Installation guide

The System Features Learn Routine

™

dictates how the unit operates. Due to the number of steps, they have been

broken up into two menus. It is possible to access and change any of the feature settings using the Valet

/Program

switch. However, this process can be greatly simplified by using the optional DEI Bitwriter or Personal Computer

Interface, P/N 996T. Any of the settings can be changed and then assigned to a particular transmitter, up to four, a

feature called Owner Recognition. Each time that particular transmitter is used to disarm the system, the assigned

feature settings will be recalled. Owner Recognition is only possible when programming the unit via the 996T or the

998T DEI Bitwriter.

Using the optional DEI Bitwriter or PC Interface, the learn routine may be locked. Make sure the learn routine is

unlocked before programming features. If the siren generates one long chirp when attempting to program the unit,

the learn routine is locked and must be unlocked using the DEI Bitwriter or PC before proceeding.

1. Open a door: (The H1/5 GREEN wire or the H1/7 VIOLET wire must be connected.)

2. Ignition: Turn the ignition on, then back off: (The H1/9 YELLOW wire must be connected.)

3. Select a menu: Press and HOLD the Valet

/Program button: (The Valet

/Program button must

be plugged into the blue port.) After three seconds the siren will chirp once indicating entry to

the Basic Features Menu #1. If this is the menu you wish to access, release the button and go

on to step 4. If the button is not released, you will jump to the Advanced Features Menu #2 and

the siren will chirp twice. Once you have selected the desired menu, release the

Valet

/Program button and then go to step four.

4. Select a feature: Press and release the Valet

/Program button the number of times corre-

sponding to the step you wish to change. For example, to access the third feature, press and

release three times. Then press the button once more and HOLD it. The siren will chirp the

number of times equal to the step you have accessed.

5. Program the feature: While holding the Valet

/Program button, you can toggle the feature on

and off using the remote transmitter. Pressing Button I will select the one chirp or default set-

ting. Pressing Button II will select the two chirp setting. (See Transmitter/Receiver Learn

Routine section of this guide.)

NOTE: The Valet

pulse count feature (2-5) and the Channel three timed output (2-9) have five

possible settings each. Pressing channel 2 will toggle through all the possible settings.

6. Release the Valet

/Program button.

SYSTEM FEATURES LEARN ROUTINE