Installation guide

The system stores the last two full triggers in memory.These are not erasable. Each time the unit sees a full trigger,

the older of the two triggers in memory will be replaced by the new trigger. To access long term event history:

1. With the ignition off, press and hold the Valet

/Program switch.

2. Turn on the ignition.

3. Release the Valet

/Program switch.

4. Press and release the Valet

/Program switch within 5 seconds. The LED will flash in groups

indicating the last two zones that triggered the unit. The LED will flash for one minute or until

the ignition is turned off.

NOTE: The Warn Away

triggers are not stored to memory and will not be reported.

No additional parts are required to add the optional VRS

feature. However for the VRS

feature to be effective, the

8618 Starter Kill Relay must be installed. The VRS

feature can be activated with the remote transmitter and deac-

tivated with the valet switch. If the VRS

option is selected it is recommended to program the Valet switch to

respond to more than one pulse for maximum security. (See System Features Learn Routine section of this guide.)

To arm VRS

1. Turn the ignition to the ON position.

2. Press on the transmitter for 1 second.

The parking light will flash once and the siren will chirp once to confirm that the VRS system is armed and will

enter the trigger sequence next time a door is opened and then closed.

To disarm VRS (before siren begins chirping):

1. Turn the ignition to the ON position.

2. Press on the transmitter for 1 second.

The parking lights will flash twice and the siren will chirp twice to confirm that the VRS

system is disarmed.

OPTIONAL VEHICLE RECOVERY SYSTEM (VRS

)

LONG TERM EVENT HISTORY