Installation guide

H1/10 BROWN

(+) siren output: Connect this to the red wire of the Revenger

siren. Connect the black wire of the

siren to (-) chassis ground, preferably at the same point you connect the control module’s black ground wire.

H1/11 RED

(+)12V constant power input: Before connecting this wire, remove the supplied fuse. Connect to the

battery positive terminal or the constant 12V supply to the ignition switch.

NOTE: Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the 10A fuse

in the harness for this purpose. This fuse protects the module itself.

H1/12 RED/WHITE

200 mA (-) channel 2 output: When the system receives the code controlling channel 2 for

longer than 1.5 seconds, the red/white will supply an output as long as the transmission continues. This is often

used to operate a trunk/hatch release or other relay/driven function.

IMPORTANT! Never use this wire to drive anything but a relay or a low-current input! The transis-

torized output can only supply 200 mA of current. Connecting directly to a solenoid, motor, or other

high-current device will cause it to fail.

This system can control two common power door lock types without any additional parts! With certain vehicles, or

if an actuator is to be installed, either a 451M Door Lock Relay Satellite or two relays will be required.

IMPORTANT! If you mistake a Type C direct-wired system for a Type A positive-pulse system, the

module will be damaged!

HARNESS 2, (+/-) DOOR LOCK OUTPUTS

GREEN (-) LOCK, (+) UNLOCK OUTPUT

EMPTY UNLESS USING 451M

BLUE (-) UNLOCK, (+) LOCK OUTPUT

H2/A

H2/B

H2/C