Owner`s manual

code hopping

The receiver and transmitter use mathematical formulas called algo-

rithms to change their codes each time the transmitter is used. This

Code Hopping

technology has been developed to increase the securi-

ty of the unit. By following this set code sequence, the receiver and

transmitter stay synchronized, even if the remote transmitter is used

out of range of the vehicle. If, however, the transmitter is pressed many

times out of range of the vehicle, or the battery is removed, the trans-

mitter may get temporarily out of sync and fail to operate the system.

To resynchronize the remote transmitter, simply press several

times within range of the vehicle. The system will automatically resyn-

chronize and the transmitter will respond normally.

rapid resume logic

Your security system stores its current operational state in non-volatile

memory, so that if power is lost and then reconnected, the system will

recall the stored state from memory. For example, if the system is in

Valet

Mode when the battery is disconnected, it will still be in Valet

Mode when the battery is reconnected. This applies to all system fea-

tures, including arming, disarming, and Valet

Mode.